Page 1 of 1

PostPosted: Wed Mar 14, 2001 8:52 pm
by Guest
Does anybody have a boat that my be around hull number 345. I would like to talk about your mast step and see how you fell about its placement.
Ken
#345

PostPosted: Wed Mar 14, 2001 10:08 pm
by Guest
Ken-

I have hull #334 so it should be the same production run as yours. I had to drill additional sets of holes to be able to set the mast butt where it needed to go according to suggestions in the tuning guides, etc.

Good luck with it.

Scott

PostPosted: Thu Mar 15, 2001 2:16 pm
by Guest
I just bought #340, but I haven't had a chance to sail it yet. The dealer raced it at KW and they had to redrill to correct mast step placement as well. I feel better knowing that my boat wasn't the only one.

PostPosted: Fri Mar 16, 2001 1:05 am
by Guest
Well, That is not a new problem. The mast step on Javelin #36 had been moved twice as evidenced by the multiple sets of holes. You would think that they would not drill any holes if they couldn't locate them correctly. If multiple holes constitutes "lightening" I wish that they did it elsewhere. See you all in Ft. Worth tomorrow.

PostPosted: Tue Mar 27, 2001 6:58 pm
by Guest
Tom,
You said you have moved your mast step setting twice? Every one else seems to think that the (north sails) tuning guide is right. Is there any other seeting worth trying? I was just wondering if i am the only guy not putting my step where it says to.
Ken