Page 1 of 1

PostPosted: Tue Apr 10, 2012 9:32 pm
by Guest
Ok finnaly got my new furler and headstay pre-swagged with the connectors on. The measurement is 32'10" with the turnbuckle fully out . Pretty much what the old one was ( off by 1/4 inch I guess due to stretch) . What I was wondering is the section of foil I need to cut is stated in the harken manual as 1' 4" but our old is 1' 2". IS there something I'm missing ? Is there some adjustment I'm missing ? Also any advice on getting the whole thing put together w/o turning grey ? Thanks !!!

[Posted by: evanwellens%40gmail.com
]

PostPosted: Tue Apr 10, 2012 10:42 pm
by raywulff
Add a turnbuckle at the base and hit the bar!