Page 1 of 1

PostPosted: Sat Sep 16, 2006 4:14 pm
by derek_jackson
Hi all, I am suspecting that I may have some wet core around my port chainplate as there is a small bulge in the deck around the chainplate. I've seen no evidence of water on the inside but I'm still a little worried. Can someone give me a step by step on how to remove the wet core, and re-bed the chainplate area.
Thanks in advance!
DJ

PostPosted: Sat Sep 23, 2006 7:32 pm
by Guest
Remove the chain plate cover. Remove the chain plate iteself. Put an Allen head wrench upside down in your drill and use it as a router to remove the wet core. Fill the void with thickened resin, I found the West System the easiest to use.
Nigel Beale
J Spot
Hull 103

[Posted by: Nigel Beale
]

PostPosted: Sun Sep 24, 2006 3:34 pm
by derek_jackson
Thanks J Spot. Sounds easy enough.... how much would you thicken the resin?