Page 1 of 1

PostPosted: Sun Apr 08, 2007 7:55 pm
by Guest
What is the best solution for intrusion of water at the sprit. Has someone come up with the no water solution?

PostPosted: Mon Apr 09, 2007 8:51 am
by Guest
There are several "homebuilt" solutions out there, most of which involve mounting a ring-shaped gasket of neoprene or similar material to the end of the sprit housing. It can be held in place by screws, plates, or fiberglass covers. Where are you located?

[Posted by: chrismorlan
]

PostPosted: Mon Apr 09, 2007 8:10 pm
by Guest
Here's a contact for gaskets I've used:
Mark Trzepacz
Seal Applications & Manufacturing
Expresseal Division
Apple Rubber Products, Inc.
204 Cemetery Road
Lancaster, New York 14086
U.S.A.
PH: 716-684-7649 ext. 431
FX: 716-684-1678
www.expresseal.com
www.applerubber.com

[Posted by: Peter Frosig
]

PostPosted: Sun Jul 15, 2007 9:40 am
by Guest
I followed your tip and here is how it worked. I applied two gaskets, and rotated one vs the other then applied Kite tape around the gaskets, the intrusion stopped. Later, testing at 15.5 knts and choppy seas I would say we pressurized the fittings and the repair gets two thumbs up!

PostPosted: Tue Aug 14, 2007 10:26 am
by Guest
<a href="">coverage employed health insurance self</a> <a href="">cheap car insurance for young drivers</a> <a href="">mortgage quotes</a> <a href="">instant credit card</a> <a href="">boat insurance online quote</a>

[Posted by: sad
]