Archive through February 03, 2005

Maintenance Topics

Moderator: forumadmin

Postby Guest » Tue Jul 06, 2004 11:15 pm

My, Spinnaker halyard keeps fraying at the exit point at top of mast. The exit point looks modified (used boat) as there are two screws one on top and one on bottom. I can see that the stock boat had 3 screws on each side. Can some one tell me what the stock part is? or if anybody has had the same problem? when not racing Class I do Like to reach allot but this should not be a problem


Later

#219

[Posted by: Jud Cary
]
Guest
 

Postby Guest » Wed Jul 07, 2004 8:06 am

Check here:
http://www.hallspars.com/Merchant2/merc ... de=j80_mst
SHEAVE BOX FOR SPINNAKER HALYARD (RON-RF-460)
SHEAVE BOX FOR SPINNAKER HALYARD $17.64
I have replaced mine once (Hull 45) and it is held in with three screws on each side.

[Posted by: Chris Morlan
]
Guest
 

Postby Guest » Fri Feb 04, 2005 12:10 am

Jud-
An easy way to solve your problem would be to put a stopper ball on your halyard right above your schakle this will keep the line from fraying on the point you said was modified. If you want to replace the whole exit at the top of the mast use the
SHEAVE BOX FOR SPINNAKER HALYARD (RON-RF-460)
SHEAVE BOX FOR SPINNAKER HALYARD $17.64

That should fix your problem.

Jonathan





[Posted by: Jonathan Kovach
]
Guest
 


Return to Maintenance Topics

Who is online

Users browsing this forum: No registered users and 1 guest